P075CShift Solenoid G Stuck On
- Generic OBD-II code · Powertrain
- Turns on the check-engine light
- Matters for the ITP
- Can trigger limp mode
- Needs a drive cycle to confirm a fix
- How the car detects it
- Shift solenoid G only exists on transmissions with seven or more solenoids. Ford's 10R80 and 8F35 use solenoids A–F, GM's 9- and 10-speeds report clutch pressure valve codes, the Allison 1000 uses three; the only documented user of the G block is Hyundai/Genesis' 8-speed, which assigns P075A and P075D to its on/off solenoids. P075C means solenoid G is commanded off but its clutch stays applied, like P0752 for solenoid A. No manufacturer document available to us uses this code; Ford's 10-speed bulletins end at solenoid F. The description follows the scheme for solenoids A and B.
- What you may notice
- Wrong gear, tie-up
- Limp mode
- Check engine light
- Likely causes
- LikelyShift spool sticking in the applied position
- PossibleSolenoid stuck open or leaking
- PossibleClutch not releasing (burnt or stuck)
- PossibleContaminated or wrong fluid
- Inspection (ITP)
- Matters for the ITP. While the check-engine light is on, the car fails the emissions check.
- Repair
- Hard · Usually a job for a workshop.Typical cost: €200 – €3,500
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.