U3510Control Module Missing Calibration
- Generic OBD-II code · Network
- Turns on the check-engine light
- Can trigger limp mode
- How the car detects it
- U3510 says a control module lacks a calibration it needs: either the data set that adapts its software to the vehicle was never written or got lost, or a learned calibration such as a sensor alignment has not been done. CARB makes every emission-critical unit report a calibration ID and a verification number, so empty or invalid data cannot pass unnoticed. No maker publishes U3510 itself, but related codes show both meanings: Hyundai's chassis code C2702, worded the same way, appears on 2019 Elantra blind-spot radars (bulletin 19-BE-016H, new radar plus mounting-angle check), and Stellantis' C0529-00 for the steering angle sensor of the 2023 Dodge Hornet lit the MIL until the wheel was turned lock to lock (08-148-23, EPS update).
- What you may notice
- Function of the affected module unavailable or limited
- Warning lamp of the related system, MIL if the module is OBD-relevant
- Fault appears right after a module replacement or software update
- Likely causes
- LikelyNew or used module installed without programming or setup
- PossibleSoftware update aborted, e.g. by low 12 V voltage or lost connection
- PossibleRequired learn or alignment routine not performed after repair
- RareInternal memory of the module losing its stored data
- Repair
- Workshop only · Usually a job for a workshop.Typical cost: €0 – €300
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.