U302DIgnition Output On/Start
- Generic OBD-II code · Network
- How the car detects it
- U302D concerns the output that powers the On/Start circuits, i.e. everything that has to work with the engine running and through cranking but not in Off or Accessory. On GM's 2012 pickups the body control module handles this by switching the coil of the run/crank relay over circuit 5199. GM bulletin PIT5817A, covering 2020–2021 models such as Escalade, Tahoe, Corvette and CT5, shows what goes wrong on that side: the BCM keeps driving ignition main relay KR73 after shut-off, circuit 5199 stays live and the battery runs down, while engine, transmission and brake controllers store P2535 and the cluster stores U300D; the repair is a new BCM. GM records that case through input codes in the receivers, not as U302D. A module that checks its own on/start output would catch the same fault at the source. No manufacturer documents U302D publicly.
- What you may notice
- Battery repeatedly flat, often after a remote start
- Engine lamp at start-up with P2535 stored in engine and transmission modules
- No start or modules without power if the output fails open
- Likely causes
- LikelyRelay driver in the body control module staying on after shut-off
- PossibleIgnition main relay contact welded or relay not pulling in
- PossibleRelay coil control wire open or shorted to voltage
- RareRetrofitted device feeding voltage back into the run/crank circuit
- Repair
- Medium · Usually a job for a workshop.Typical cost: €20 – €900
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.