P2637Torque Management Feedback Signal A
- Generic OBD-II code · Powertrain
- Can trigger limp mode
- How the car detects it
- Many automatic transmissions ask the engine to cut torque briefly during an upshift and then check whether the engine actually did so. P2637 is stored by the transmission controller when that feedback for request A shows the engine did not follow. Allison names it Shift Energy Management (SEM) on its 3000/4000 series: behind Cummins L9 and X15 engines (EPA17 version) the engine failed to track the torque request closely enough, the CHECK TRANS lamp came on and Cummins fixed it with an ECM recalibration (TSB210020), with no change to Allison hardware or software. Cummins found the same on B6.7 engines in 2017 (J1939 SPN 513, FMI 7), and Navistar linked P2637 to Allison 1000/2000 calibrations causing quick, harsh upshifts. P2641 covers request B. Expect firm shifts or limited gears.
- What you may notice
- Check transmission lamp on
- Harsh or too quick upshifts
- Gear range limited
- Likely causes
- LikelyEngine control module calibration not following the torque reduction request
- PossibleTransmission calibration not matched to the engine
- RareJ1939/CAN data link fault between engine and transmission
- Repair
- Workshop only · Usually a job for a workshop.Typical cost: €80 – €400
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.