P2622Throttle Position Output Circuit High
- Generic OBD-II code · Powertrain
- Matters for the ITP
- How the car detects it
- P2622 means the throttle position output line sits too high, typically because it is shorted to a supply wire or the driver in the sending module cannot pull it down. The receiver would read a value resembling wide-open throttle even at idle, which can confuse shift scheduling or torque calculations. There is no public manufacturer documentation for this exact code. CARB's comprehensive component rules oblige makers to detect shorts on output circuits, and GM's short-to-power check on its crank output (impedance toward power of 0.5 ohm or less, sampled every 100 ms) shows how such a test is commonly built. Inspect for a wire rubbing against a battery or ignition feed and for back-feed through a connector. P2620 is the open line and P2621 the short to ground.
- What you may notice
- Stored code in the engine module
- Receiver acts as if at full throttle (harsh or late shifts)
- Likely causes
- LikelyOutput wire shorted to a battery or ignition feed
- PossibleDriver in the sending module unable to pull the line low
- RareBack-feed through a damaged connector
- Inspection (ITP)
- Can matter for the ITP: it concerns the emissions system.
- Repair
- Medium · Usually a job for a workshop.Typical cost: €50 – €600
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.