P0949Auto Shift Manual Adaptive Learning Not Complete
- Generic OBD-II code · Powertrain
- Needs a drive cycle to confirm a fix
- How the car detects it
- Status code for an automatically shifted manual gearbox: the control unit has not yet finished learning its adaptation values, above all the clutch touch point and the end positions of the shift actuators. Such learning runs after a new control unit, clutch or actuator, after a software update and sometimes after the battery was disconnected; Hyundai and Kia patents show how the touch point is found and corrected from shaft speed changes. No manufacturer documents this exact code publicly. The code is a reminder rather than a hardware fault; launch and shifts may be jerky until learning is done. P0950 to P0954 cover the manual control circuit, P0806 to P0808 the clutch position sensor. MIL use depends on the maker.
- What you may notice
- Jerky launch or rough shifts
- Gearbox warning or message to perform teach-in
- Restricted gear selection until learning completes
- Likely causes
- LikelyRelearn not run after clutch, actuator or control unit replacement
- PossibleAdaptation values erased by software update or battery disconnection
- PossibleLearning aborted by low voltage or worn clutch outside the learn window
- Repair
- Medium · Usually a job for a workshop.Typical cost: €50 – €250
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.