P0825Gear Lever Push-Pull Switch (Shift Anticipate)
- Generic OBD-II code · Powertrain
- How the car detects it
- P0825 concerns a switch on the selector that reports pushing or pulling the lever – sequential + and – shifting – or the start of a shift movement, hence 'shift anticipate'. Its purpose: the control unit of an automated manual gearbox can prepare clutch and engine torque before the actual gear change is detected; a LuK patent describes such shift-intent detection, which reports intent when the lever signal exceeds a filtered, load-dependent reference and cancels on a reversal. A fault is typically a switch reporting 'pressed' without lever movement or never, implausible against the X/Y sensors. No manufacturer document with P0825 is available to us. Shift-intent detection is then off, gear changes are slower or sequential shifting is disabled.
- What you may notice
- Delayed or jerky gear changes (automated manual)
- Sequential tapping not working
- Transmission warning in the cluster
- Likely causes
- LikelySwitch in the selector faulty or sticking
- PossibleWire or connector to the selector assembly
- PossibleLiquid or dirt in the shift gate
- RareControl module
- Repair
- Medium · Usually a job for a workshop.Typical cost: €80 – €600
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.