P063EAuto Configuration Throttle Input Not Present Bank 1
- Generic OBD-II code · Powertrain
- Turns on the check-engine light
- Matters for the ITP
- Can trigger limp mode
- How the car detects it
- Some modules configure themselves at start-up by detecting which inputs are present. P063E means the module expects a throttle position input for bank 1 but does not detect it. Unlike circuit codes such as P0122/P0123 or P2135, which judge a present but faulty signal, this says the input was not found for the configuration. No manufacturer document or patent available to us describes this check; the explanation is derived from the J2012 wording. CARB requires input components to be checked for circuit continuity and plausibility, and modules with several variants to detect a wrong one. Possible causes are an unplugged throttle body or open wiring, or software meant for a different vehicle. Without a throttle signal an electronic throttle runs in limp mode.
- What you may notice
- Check engine light
- Limp mode, reduced power
- Rough idle, poor throttle response
- Additional throttle circuit codes
- Likely causes
- PossibleThrottle sensor or unit not connected, connector or wire open
- PossibleWrong module software or variant for the vehicle (module from another model)
- RareFaulty throttle unit
- RareInternal module fault
- Inspection (ITP)
- Matters for the ITP. While the check-engine light is on, the car fails the emissions check.
- Repair
- Medium · Usually a job for a workshop.Typical cost: €50 – €500
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.