P05CCCold Start A Camshaft Position Timing Performance Bank 1
- Generic OBD-II code · Powertrain
- Turns on the check-engine light
- Matters for the ITP
- Needs a drive cycle to confirm a fix
- How the car detects it
- During catalyst heating after a cold start the engine module commands a specific cam phaser position for more residual gas and exhaust heat; CARB requires this to be monitored under codes separate from the normal cam codes. These 'performance' codes are GM's current form (since about 2015/16; older GM engines and Ford use the direction codes P052A ff and P054A ff): fault when commanded and actual position differ by more than 4° or 6° once the target is stable. P05CC watches intake camshaft A on bank 1 – the cold-start counterpart of P0011. GM's 3.0 L twin turbo sets it above 4°, 60 of 100 samples, type B; the 2.0 L turbo in the Envision above 6° as type A after one trip. A GM bulletin for the 2024–25 Traverse, Enclave and Acadia (2.5 L turbo, electric phaser) names a damaged phaser motor with rattle, together with P0011/P0016.
- What you may notice
- Check engine light on (GM mostly after two trips)
- Often no noticeable symptoms, possibly rough cold idle
- Rattle from the timing drive (GM electric phaser)
- Likely causes
- LikelyInsufficient cold oil supply: wrong viscosity, low level, worn oil
- PossibleOil control valve sticking or screen clogged
- PossiblePhaser worn or lock pin not releasing; on electric phasers a damaged phaser motor
- RareTiming chain stretched or skipped
- RareEngine module software
- Inspection (ITP)
- Matters for the ITP. While the check-engine light is on, the car fails the emissions check.
- Repair
- Medium · Usually a job for a workshop.Typical cost: €100 – €1,500
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.