P04CEEGR Temperature Sensor C Circuit
- Generic OBD-II code · Powertrain
- Turns on the check-engine light
- Matters for the ITP
- Needs a drive cycle to confirm a fix
- How the car detects it
- Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. The code standard allows up to four EGR temperature sensors, A to D – for example before and after the cooler, or in the high- and low-pressure circuits; which is which depends on the maker. Sensor C is the third of them, usually an NTC whose low voltage means hot. P04CE is its general circuit fault, without separating low and high. FCA lists sensor C codes for its part 68142905A (Ram 2014 6.4 and 3.0 litre, Jeep and Dodge 3.6 Pentastar 2016) together with P040B, P0401 and P2457. Thresholds are not published. Without a valid temperature the EGR flow model is wrong, so the module uses a substitute value or switches EGR off.
- What you may notice
- Check engine light on
- Usually no change in driving (EGR on a substitute value or off)
- Possibly EGR flow or cooler codes (P0401, P2457)
- Likely causes
- LikelyOpen or poor contact in signal or ground line
- LikelyConnector or wire at the sensor corroded or worn by heat and vibration
- PossibleSensor faulty (element broken or sooted)
- RareEngine module input
- Inspection (ITP)
- Matters for the ITP. While the check-engine light is on, the car fails the emissions check.
- Repair
- Medium · Often possible to do yourself.Typical cost: €60 – €300
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.