P048FExhaust Pressure Control Valve A Position Sensor/Switch Circuit Intermittent/Erratic
- Generic OBD-II code · Powertrain
- Turns on the check-engine light
- Matters for the ITP
- Needs a drive cycle to confirm a fix
- How the car detects it
- An exhaust pressure control valve is an electrically driven flap in the exhaust with a position sensor or end-position switch, usually inside the actuator. Valve A is the first such flap; Bentley's V8 assigns A to bank 1 and B to bank 2. Documented uses are the flap behind the particulate filter of VW's and Audi's 2.0 TDI, which raises back pressure for the low-pressure EGR, and the sound flaps of Audi and Bentley. P048F means valve A's position signal jumps, drops out briefly or changes faster than physically possible. Bentley stores sporadic sensor faults under the low code with a sporadic status instead. No manufacturer document available to us uses this code; the description follows the sibling codes P048B–P048E and CARB.
- What you may notice
- Check engine light on
- Flap without function, exhaust sound changed
- VW/Audi TDI: EGR fault P0401 possible
- Likely causes
- LikelyLoose contact or corrosion at the actuator connector
- PossibleWire broken by vibration or heat
- PossiblePosition sensor worn
- Inspection (ITP)
- Matters for the ITP. While the check-engine light is on, the car fails the emissions check.
- Repair
- Medium · Usually a job for a workshop.Typical cost: €50 – €600
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.