P03BDCylinder 5 Pressure Sensor Circuit
- Generic OBD-II code · Powertrain
- Turns on the check-engine light
- Matters for the ITP
- Needs a drive cycle to confirm a fix
- How the car detects it
- Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. This code concerns cylinder 5. P03BD is the general circuit code for this pressure sensor, meant for modules that do not separate open circuits and shorts into low and high. The only manufacturer we found using this code family, GM's European 2.0 CDTI four-cylinder diesel (Saab 9-5), splits such faults into low and high codes for cylinders 1 to 4, and VW's US 2.0 TDI engines with pressure-sensing glow plugs use their own codes (P13CE ff). For cylinder 5, which only engines with at least 5 cylinders have, no manufacturer document available to us uses the code; the description follows that logic and CARB. The sensor has three wires (5 V reference, ground, signal); without it the module drops combustion control for that cylinder.
- What you may notice
- Check engine light on (often after two trips)
- Usually barely noticeable – combustion control for the cylinder is switched off
- Possibly rougher running, more noise or slightly higher consumption
- Likely causes
- LikelyConnector at the pressure-sensing glow plug loose or corroded
- PossibleReference, signal or ground wire open or shorted
- PossibleSensor electronics in the glow plug faulty
- RareEngine module (reference voltage or input)
- Inspection (ITP)
- Matters for the ITP. While the check-engine light is on, the car fails the emissions check.
- Repair
- Medium · Usually a job for a workshop.Typical cost: €50 – €400
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.