P024CCharge Air Cooler Bypass Position Sensor A Circuit
- Generic OBD-II code · Powertrain
- Turns on the check-engine light
- Matters for the ITP
- Needs a drive cycle to confirm a fix
- How the car detects it
- The charge air cooler bypass is a flap or valve that routes compressed air around the charge air cooler, so the engine and exhaust warm up faster after a cold start; when warm it closes or opens partly to control intake air temperature. It is driven by an electric motor with a built-in position sensor or by a solenoid and vacuum can. Its position sensor is usually built into the actuator, with a 5 V reference and a ratiometric signal. P024C is the general circuit fault of the position sensor, for manufacturers that do not split low and high. Bypass control is then switched off and the flap stays in its rest position. No manufacturer document using this code was found – GM and Ford do not use the bypass codes; the description rests on CARB's component monitoring requirement and a Bosch patent on the bypass valve.
- What you may notice
- Check engine light on
- Depending on the rest position: longer warm-up or higher charge air temperature with slight loss of power
- Often nothing noticeable while driving
- Likely causes
- LikelyConnector or wiring to the actuator's sensor part
- PossibleBuilt-in position sensor faulty
- Rare5 V reference disturbed by another sensor
- RareEngine module
- Inspection (ITP)
- Matters for the ITP. While the check-engine light is on, the car fails the emissions check.
- Repair
- Medium · Often possible to do yourself.Typical cost: €30 – €450
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.