P0136O2 Sensor Circuit Bank 1 Sensor 2
- Generic OBD-II code · Powertrain
- Turns on the check-engine light
- Matters for the ITP
- Needs a drive cycle to confirm a fix
- How the car detects it
- The oxygen sensor after the catalytic converter on bank 1 (sensor 2) is a switching sensor (about 0.1–0.9 V) used for converter monitoring and fine mixture trim. P0136 is the general circuit code, and its exact meaning varies by manufacturer. Ford sets it as 'no activity' in a functional check: if the sensor never swings beyond about 0.42/0.48 V despite rich and lean phases – if needed after forced enrichment and leaning – once per drive cycle. Opel/GM Europe set it if the average voltage stays outside 400–500 mV after 10 min of closed loop; older Bosch Motronic if it stays at 0 V for 200 s despite heating. GM North America does not use P0136. When it fails, the control module stops the downstream trim and cannot evaluate the converter; there is no limp mode.
- What you may notice
- Check engine light on (usually after two drive cycles)
- Catalyst monitor readiness not set
- Slightly higher consumption possible without downstream trim
- Likely causes
- LikelyDownstream sensor aged or poisoned (stays in the middle band)
- PossibleSignal or ground wire open or high-resistance, connector corroded
- PossibleSensor heater failed (sensor stays cold)
- RareExhaust leak ahead of the sensor
- RareControl module or software
- Inspection (ITP)
- Matters for the ITP. While the check-engine light is on, the car fails the emissions check.
- Repair
- Easy · Often possible to do yourself.Typical cost: €60 – €250
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.