P00F0Intake Air Temperature Sensor 3 Circuit High Bank 2
- Generic OBD-II code · Powertrain
- Turns on the check-engine light
- Matters for the ITP
- Needs a drive cycle to confirm a fix
- How the car detects it
- Intake air temperature sensor 3 is a third air temperature sensor in the intake path. On documented turbocharged engines with a humidity sensor it is the manifold temperature sensor behind the charge air cooler, an NTC thermistor read directly by the engine control module and used for cylinder filling and ignition timing. The numbering of intake air temperature sensors differs between manufacturers. P00F0: The signal is above its valid range, i.e. very high resistance from an open circuit; the control module then reads an extremely low temperature. No manufacturer description naming this exact code was found; bank 2 codes are intended for engines with two separate intake paths.
- What you may notice
- Check engine light on
- Usually no noticeable symptoms; substitute value used
- Slightly reduced power through knock protection possible
- Likely causes
- LikelyOpen circuit, connector off or corroded
- PossibleSensor open internally
- RareGround wire interrupted or control module faulty
- Inspection (ITP)
- Matters for the ITP. While the check-engine light is on, the car fails the emissions check.
- Repair
- Easy · Often possible to do yourself.Typical cost: €60 – €300
- Related codes
Explanation from obdex (CC0), exactly as the app shows it. Guidance only; confirm with a workshop.